- Flexible Weld ASssemblies
- Naming Fields in Virtual Part
- Why can't I roll?
- Linked Patterns of Flexible Assemblies
- Highlight Overridden Dimensional Values
- Suppression of Child Section View
- Add Apply to Surface Tool
- Make Dynamic Parts Available to Assemblies
- Multiple Hatch Selections
- Alignment of Broken Aux Views
- Independent Control of XYZ Translations and Rotations
- Separate Floating "Simulation Panel "
- Definable Point to Anchor Tables
- On-the-Fly Dimension Modifiers
- Settable Workplane & Axis Colors
- Better Flexibility Between Spreadsheets and Drive Parts and Assemblies
- Ability to Change Drive Dimension
- Allow View Scale to be Used in the Title Block
- Recent Open Files List in Open Dialog Box
- Single Part Representations
- Folders in The Browser
- Quickly Check Assembly Constraints
- Detail View Identifier with a Leader
- Tool Tips that Show the File Name of Selected part
- Creation of Service Loops in Cable /Harness
- Revision Table Tab in Part iProperties
- Identification of Suppressed Component Patterns
- Ability to View Multiple Drawing Sheets Side by Side
- Option to Break Dimension Lines
- Component Pattern with Holes Created at Assembly Level
- Changeable Default Thread Sizes & Depths
- Control of Tables - Column and Row Visibility
- Retain Values in Surface Texture Dialog
- Abbility to Unfold Spline Shaped Parts
- Multiple Wire Harness Views in an IDW
- Harness Wires Shown as the Same Length in a Nail board View
- Be able to use Presentation Files In IV Studio
- Notification of Parts Updated During Opening a Assembly
- Reorder Prompted Entries
- Access to IV's Dialog Boxes thru the API
- Ability to Edit Detail View
- Automatic IDW Creation of Derived Part/assembly
- Foreshortened Radii with Center Mark
- Edittable 3D Points
- �Ability to Change View Orientation After Creation
- Pattern Type Tool
- Boundary Pattern
- Browser Grouping of Features/Parts/Assemblies
- Casting Module
- Make CSV File Work Like XML Updating Wire Numbers
- Coil Feature that Follows Multiple Line Section Paths
- Ability to Change Visibilty of Component Patterns in IDW
- Visiblity of Placed LOD Component
- Tubing/Pipe Centerline Bisector
- Ability to Select Existing Weld Joint in Model/Assembly
- Rolled Shapes That Can Be Flat Patterned
- Variable Value Constraints
- Wire Segment Splitting
- One Button Wire Removal
- Lofted Sheet Metal Parts