View Full Version : Volume between Surfaces
2004-10-27, 09:29 PM
I have two surfaces and I have run existing ground x-sects on both. I already used a grading object to rough out my volume but I wanted to check it by comparing surfaces. When I try to get a volume between two surfaces, I get the no vertical exists message. Do I have to run a profile for each surface as well?
I am sincerely grateful for any wisdom!!
2004-10-28, 12:00 PM
You will be working at or near the bottom of the Terrain menu.
Here use >Select Current Stratum
Name the stratum and select Surface1 and Surface 2
Then Define your Site and your sample increment (NxM grid)
At this point you will be able to run any of the three surface
volume calculations on your site.
(When are you going to bring me to Kingman???) 8)
Powered by vBulletin® Version 4.1.11 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.