yangcheng2008
2009-06-19, 02:38 AM
The problem is that pipe network structures are not being displayed in the viewport. In fact, I cannot even select the structure part. If I drag a selection box over where the part should be, look in the properties, It shows everything else, except the structure.
The structure is a sanitary manhole, connected to 2 pipes. The structure part is defined with a block in plan mode. The block is a simple circle (layer “0-BLK-500”) filled with a hatch color 255 of the same layer. I have made sure that the outer circle is above the hatch in block editor.
I have all layers on and unfrozen, viewport layers are all on as well.
I have exhausted every option in style menu.
I have simply run out of ideas on this one.
Any help with be greatly appreciated.
The structure is a sanitary manhole, connected to 2 pipes. The structure part is defined with a block in plan mode. The block is a simple circle (layer “0-BLK-500”) filled with a hatch color 255 of the same layer. I have made sure that the outer circle is above the hatch in block editor.
I have all layers on and unfrozen, viewport layers are all on as well.
I have exhausted every option in style menu.
I have simply run out of ideas on this one.
Any help with be greatly appreciated.