View Full Version : File reference dialog box
nextvkin
2009-07-20, 12:23 PM
Hi,
Can anyone tell me how to bring up the xref dialog box in Trueview 2010. Thanks.
rkmcswain
2009-07-20, 01:35 PM
Here are some tricks that work in DTV2009, but I have not tried them in 2010 yet.
http://cadpanacea.com/node/82
nextvkin
2009-07-21, 01:17 AM
Thanks for that, but my problem is I can't type any command at all, the command line doesn't accept what I type. I'm not sure what's going on. At the moment all I can do is close the file, open it again & a dialog box pops up to ask if I want to configure the xrefs & if I click ok it'll open the file with the xref dialog box open.
OK, just found a little button in the bottom right hand corner for managing xrefs. Still wondering though about typing in commands & what the commandline is for.
rkmcswain
2009-07-21, 12:12 PM
Thanks for that, but my problem is I can't type any command at all, the command line doesn't accept what I type.
Please go back and read the text in the CAD Forum link. You are correct, you cannot type commands in Trueview, but you can paste them in. I just tried it in DTV2010 and it works fine.
nextvkin
2009-07-22, 01:40 AM
You're right! Thanks for that - how in the world did you figure that out?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.