View Full Version : Hollow Metal Doors and Frames
2003-09-09, 10:53 PM
Has anyone seen a hollow metal door and frame, where the wall is cut out by the overal width of the door and frame. I find this would be very helpful when working with masonry.
Thanks in advance for your help.
2003-09-09, 11:09 PM
You need to edit the sketch lines for the 'Opening Cut' component for the family.
Offset the lines the width of the frame and assign a parameter' (see images).
2003-09-10, 03:23 AM
I believe that there is/was a hollow metal frame family in Rugi. If rugi is going to be up soon. If it's not up tomorrow, I can post it when I get to work tomorrow
2003-09-10, 03:57 AM
Thanks Chad and Trent,
I appreciate the help. Trent I'd appreciate if I could download that tomorrow if Rugi is still down. I checked a few minutes ago and it still was.
2003-09-10, 01:57 PM
Here ya go.
2003-09-10, 02:00 PM
with glass, note ones that say alum can be used just like hm.
These are all in rugi so when its available you can get them there.
2003-09-10, 02:03 PM
this is it for now, if you need a specific type ask, Ive got ones with transoms, sidelites, etc.
2003-09-10, 02:04 PM
Thanks Scott. I'll check out RUGI again.
Powered by vBulletin® Version 4.1.11 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.