PDA

View Full Version : Imaginary Parcels Exist In DWG



mdemint
2009-09-16, 05:23 PM
Hello,

I've got a drawing that I've deleted everything from... when I select all using the QSELECT, I am able to select over 3,000 parcels...

How do I get rid of these? I don't even know how they got there...

-see attached dwg-

btw I'm using Civil 3D 2009 version 4

jpaulsen
2009-09-17, 02:23 PM
If you keep your alignments in sites, parcels will be created when the alignments create closed regions. Although, I doubt that is what caused your problem here. This drawing is definitely corrupt and should be deleted. It crashed on me several times doing simple things like select ALL and using properties.

I would try to salvage the original drawing by copying the good objects to the clip board and pasting them into a new drawing.

mdemint
2009-09-17, 06:26 PM
That's what I was thinking... I'm not sure where the parcels even came from... we never created them.

I, too, noticed the Select All causing a fatal error in addition to plotting...