View Full Version : Masonry windows
2003-09-10, 07:11 PM
I have a condition where I have a stud wall behind a brick veneer. My question is when I insert a window component it is hosted to the exterior resting on the brick rather than the stud wall. How is this remedied? I have tried a number of things, but my experience is limited in Revit in general.
2003-09-10, 08:10 PM
My solution to that problem was to modify a window family, giving it a nailing fin offset as an instance parameter. If you're decent with the family editor, it should go quickly.
2003-09-10, 09:39 PM
Your veneer wall should be defined with the stud being the structural layer and the brick being a finish. Windows will then assocaite with the structural layer.
2006-08-08, 07:35 PM
I find that although the brick is the finish, the window still hosts to the entire width of the wall.
Powered by vBulletin® Version 4.1.11 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.