Piping Gap to much in Sheet

[michaelmerda]

When we open sheet or create a sheet then add our view port the gap for the piping is way to much but it looks fine in constucts. Then i open view, and spacing starts getting worse, then in sheet, its has even more space. What i am i doing wrong?.

[bradg]

I'm still using AMEP 09, but hopefully this will help you out regardless:

Go to the Options dialog (I usually just right-click the command line and select Options..), and then go to the MEP Display Control tab (you may have to use the scroll arrows in the top right to get to it). On that tab you should see a box where you can specify the Gap Width. Try changing that to whatever is is set to in your Constructs. If they're already the same value, then unfortunately I'm at a loss for ideas.

Good luck!
-Brad