Multiline Attribute Goes Astray

[dhallett]

I have a tag block with two fields and one multi-line attribute. It works fine as a non-annotative scale block, but when I tried to convert it to an annotative block, the behavior changed. The two field attributes come in OK, but the multi-line attribute always inserts at 0,0 in the drawing, no matter where the block is inserted. An attribute sync fixes it, but that’s a pain. Any ideas would be appreciated? Thanks.

[Andy.88917]

Welcome to the club!

http://forums.augi.com/showthread.php?p=1014131#post1014131

[Andy.88917]

Hey dhallett, I figured out my similar issue. I am using ACA 2008 and when I installed SP1 my problem was fixed. This might not help you since I assume you are on ACA 2010 but just thought I would mention it.