Grading Style Criteria

[jaldridge]

I appolgize if this simple question has been asked before. I did a quick forum search.

The image shows in red 3dpolylines that I used in LandDesktop to create a sump and then daylight. The corners are angular, which is what I need.

The white reflects the revised sump bottom as a feature line and daylighted in Civil3D, but I cannot find in the Toolspace Settings tab how to control the radial corners. In summary I cannot have radial corners and I cannot locate where this is controlled.

Thank you in advance

Jesse

[Glenn Pope]

Currently Civil 3D can't do what you want. This has been added to the wish list located here (http://www.augi.com/civil3d/ballot.asp). I would recommend you go add your vote for it.

[jaldridge]

Thanks for the reply
I also found someone else asking last year with no reply. http://discussion.autodesk.com/forums/thread.jspa?messageID=6074395

I will be voting......Argh!!!

[brian.hailey933139]

It may not be the best solution in the world but here is a method I came up with. Repeat for each corner:

http://screencast.com/t/553UY12B

Video is about 3 minutes long.

[jaldridge]

Thanks Brian.
Very helpful video

[denisgonzalezg189]

I had this very same problem a while ago, I had to use good old LDT