PDA

View Full Version : View/Edit Corridor Sections



Ryan-13
2010-04-29, 10:06 PM
I am working on a corridor with a very simple assemby. When I apply my assembly through multiple baselines and then use the object viewer I have no problem with the way my corridor looks, all points and links show up as they should. However when I try to use the "View/Edit Corridor Sections" command and try to scroll through my sections. They are very inconsistent, in most cases not all my links and points show up in the section viewer, in other cases half of my assembly shows up but i cannot get my existing ground to show up in all the sections either. Anyone had this problem before?

bruce.klug
2010-04-30, 05:00 AM
Can you post a picture of the one with half the assembly?

Make sure you have your Existing surface on and displayed in plan view before viewing your corridor sections.