epipkin
2010-06-30, 06:15 PM
I'm trying to combine two surfaces, one is an excavation grade, the other a finished grade. The finished grade cuts into the excavation grade and I need to create a surface that shows the deepest cuts. So, ideally CAD would look at both surfaces and and for every XY use the lowest Z to make it.
I think the attached .jpg illustrates what I'm looking to do.
It really seems like this should be possible. Any ideas?
Thanks!
I think the attached .jpg illustrates what I'm looking to do.
It really seems like this should be possible. Any ideas?
Thanks!