gleiper
2010-07-15, 04:05 PM
I've created some profiles and my existing ground line is not showing up. The line showed up perfectly when I created the profiles. I've now gone back into the drawing to make revisions and all the ex. ground lines have disspeared from the profiles. I've turned all my layers on and still no luck.
If I go to the profile view properties dialog box there is no data source listed under the existing surface profile. I'm assuming this is my problem but can't figure out how to assign the ex surface as the data source. This was all set up initially when I first created the profiles and, like I said, the line showed fine when I created the profile.
Can somebody tell me what the heck I'm doing wrong so I can get back to work!!
Thanks.
If I go to the profile view properties dialog box there is no data source listed under the existing surface profile. I'm assuming this is my problem but can't figure out how to assign the ex surface as the data source. This was all set up initially when I first created the profiles and, like I said, the line showed fine when I created the profile.
Can somebody tell me what the heck I'm doing wrong so I can get back to work!!
Thanks.