View Full Version : Move a corridor

2010-08-12, 09:35 PM
Anybody know if it is possible to move a corridor down few cm after it is created?
Or that is impossible?
If it is OK, how to do it?

Thank you.


2010-08-13, 02:08 PM
Lower the profile using the Raise/Lower PVI's command in the geometry editor.

2010-08-13, 04:59 PM
Thank you for the answer.
This I know, but the problem is that I have an alignment for railway, not highway. I wanted to make a corridor that reflects the surface of the concrete slab which is 341mm lower than the alignment.

2010-08-16, 03:10 PM
Use a generic LinkOffsetElevation subassembly to go from the assembly down 341mm. Set the omit link property to yes. Connect the other subassemblies to this one.

2010-08-17, 02:15 AM
Thank you David for the hint!
I will try tomorrow your advise!