View Full Version : corridor issue...what is the cause?
2010-09-16, 04:06 PM
I have a corridor that is not drawing correctly. It is made up of several regions depending on the section of corridor in question. The lines are crossing up with each other. i have checked my link codes and point codes they all match up.
If you look at the iso-picture below the corridor feature lines should run parallel to each other. but they do not.
2010-09-16, 09:40 PM
Try changing the branching option in the corridro properties:
2010-09-17, 12:34 PM
That fixed it
2010-10-26, 03:34 PM
This reply is to Brian,
I am having a very similar issue but I think it has to do with the point code P2. In some assemblies P2 is in a different place than it is in other assemblies. In the image capture you showed in your post I don't see any codes like P1, P2, etc. Are they just lower on the list, or should I be replacing those codes in the sub assemblies with a specific code that I want to show?
When a subassembly under the parameters tab only shows one point code (such as P2) is this always the connection point that the next subassembly attaches to?
I thought that I was understanding C3D pretty well until I see others posts and then I start doubting what I have been doing.
Powered by vBulletin® Version 4.1.11 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.