Plotting from paper space

[sampson]

I'm using AutoCADLT 2005 - when plotting from paper space the viewport window outline shows - how do I turn this off? Thanks, Wayne.

[bbapties]

create a seperate layer for the vport and make the layer "no plot"
there are many solutions to this problems using "search" option...

hope this helps

[Hippigypsy]

I'm using AutoCADLT 2005 - when plotting from paper space the viewport window outline shows - how do I turn this off? Thanks, Wayne.

You can do that one of two ways, it's been a while since I've used LT but besides the 3D and lisp it used to function the same way as regular autocad, put the viewport on it's own layer (ex-layer Mview) and go to the layer manager and click on the layer, scroll across and click on the little printer where it says "plot" when you click on it a little red line will appear on the printer, sets the layer not to plot. If that option isn't available, change the layer of the viewport to "defpoints"- it doesn't plot. good luck
Cathryn

[Glenn Pope]

Another option is to have the viewport on a separate layer and freeze it.

I wouldn't recommend placing anything on the Defpoint layer. This has the potential to cause problems. Check out this thread Zoom in PS causes lockup (http://forums.augi.com/showthread.php?t=12260&p=72604)

[Hippigypsy]

Another option is to have the viewport on a separate layer and freeze it.

I wouldn't recommend placing anything on the Defpoint layer. This has the potential to cause problems. Check out this thread Zoom in PS causes lockup (http://forums.augi.com/showthread.php?t=12260&p=72604)

I didn't know that, thanks for the info.... don't do that just out of habit...because I was trained not to put anything on defpoints, but I've had alot of jobs come across my desk that are set up that way, thought it was a good idea.
I'm going to try running "audit" on an old job that's set up that way...see what happens

[Mike.Perry]

I'm using AutoCADLT 2005 - when plotting from paper space the viewport window outline shows - how do I turn this off?Hi

Have a browse of the following thread -

Model space lines (http://forums.augi.com/showthread.php?t=4179)

+

As was suggested give the Forum search facility a try (there is lots of useful information on this very subject to be found within the Forums) -

Search Forums (http://forums.augi.com/search.php?)

Have a good one, Mike