PDA

View Full Version : Duplex Printing



Borg
2004-12-23, 03:42 PM
Has anyone ever had any luck duplex printing from AutoCAD?
I'd like to print one layout on one side and a 2nd layout on another.
Our printer is capable of duplex, however the option is greyed out
in the device properties in AutoCAD.

Win2k
A2K5
Xerox Document Centre 425ST
Novell Network

Mike.Perry
2004-12-23, 04:05 PM
Hi

Check out the following Technical Document on the Autodesk web site under the Knowledge Base section -

ID: TS64079 - Duplex printing (http://usa.autodesk.com/adsk/servlet/ps/item?siteID=123112&id=2886576&linkID=2475323)

Have a good one, Mike

Borg
2004-12-23, 04:11 PM
Thanks Mike. I suppose I should try printing to a multi sheet PDF
and go from there to the printer.

Borg
2004-12-23, 04:50 PM
Just as an FYI to anyone who might read this thread. I found that by publishing my layouts
to a multisheet DWF. I could print in duplex mode from AutoDesk DWF Viewer.