PDA

View Full Version : Transparent comment - section view



rkmcswain
2010-11-05, 01:34 PM
Is there an equivalent to the transparent command 'PSE that works in a section view?
If not, is there something else built in that will allow you to find / draw from / etc. a offset+elevation in a section view?

TIA

brian.hailey933139
2010-11-07, 05:34 PM
I don't have C3D on this computer so I'm shooting from the hip here but, I don't think there are any transparent commands for section views. I think the best way to go about this would be to throw some labels in the section view and then use those as snapping points for your linework.