doggarn.70892
2005-01-07, 08:38 PM
Would like to see Contour Labels be placed in a DTM, if done more than once, to be automatically place in the same relative position as the last Build of a DTM. When you
have a Large DTM it is a royal mess to redo that labeling over and over when you discover
an update to the DTM in question. I am specific here about the use of AECC contours Not Polylines.
have a Large DTM it is a royal mess to redo that labeling over and over when you discover
an update to the DTM in question. I am specific here about the use of AECC contours Not Polylines.