View Full Version : How would you model this in Revit CM?
2011-06-18, 06:16 AM
Like the title says. I thought that I could make a spline by points and make some sort of loft but it don't seem to get good results. Any ideas would be great.
2011-06-18, 10:31 PM
Looks like a revolve with voids carving the top away.
2011-06-20, 05:05 AM
yes I thought of that which seem like the obvious. But I thought that maybe I could host point on a circle and use a spline through points to control the "point of the form".
2011-06-20, 02:39 PM
In Revit 2011 you could try using Project Nucleus to get this type of shape.
Attached is my first pretty crude attempt at the shape. It is not all that bad. I probably need to work on the overall dimension and then maybe modify the corner conditions with a void so they are not so sharp.
Powered by vBulletin® Version 4.1.11 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.