mrfrancisleung
2011-06-21, 08:52 PM
I'm recently working on a file for the last couple days, didn't have problem before, but since this afternoon (about 2 hours ago), I cannot use either Q-Save (Ctrl+S) or Save-As.
Every time I use either functions, it display a message shown below:
Command: _qsave
Document "Z:\my documents\WorkStation\**********.dwg" has a command in progress.
Hit enter to cancel or [Retry]: *Cancel*
- OR -
Command: _saveas
Document "Z:\my documents\WorkStation\**********.dwg" has a command in progress.
Hit enter to cancel or [Retry]: *Cancel*
I even tried to audit the file to see if there's any error, but it came up with the same message
Command: audit
Document "Z:\my documents\WorkStation\**********.dwg" has a command in progress.
Hit enter to cancel or [Retry]: *Cancel*
Anyone have any solutions to solve this issue? I copy and paste the entire drawings to a blank sheet and save it for the time being. Thanks!
P.S. I replaced the file name with *****
Every time I use either functions, it display a message shown below:
Command: _qsave
Document "Z:\my documents\WorkStation\**********.dwg" has a command in progress.
Hit enter to cancel or [Retry]: *Cancel*
- OR -
Command: _saveas
Document "Z:\my documents\WorkStation\**********.dwg" has a command in progress.
Hit enter to cancel or [Retry]: *Cancel*
I even tried to audit the file to see if there's any error, but it came up with the same message
Command: audit
Document "Z:\my documents\WorkStation\**********.dwg" has a command in progress.
Hit enter to cancel or [Retry]: *Cancel*
Anyone have any solutions to solve this issue? I copy and paste the entire drawings to a blank sheet and save it for the time being. Thanks!
P.S. I replaced the file name with *****