Grading, daylight at EG and STOP

[matt.leach774968]

I am designing a project that has a 10:1 slope and then i have a 3:1 that I want to daylight to existing ground. I have got it to work but the grading does not stop at the first place it intersects the Existing Ground, it keeps going until it hits the last point where it intersects the Existing Ground. I have been trying to figure it out for a while and I feel like I'm just spinning my wheels. If you have any suggestions please let me know! Thanks for viewing this post!! :)

[brian.hailey933139]

The grading tools in C3D are smarter than the old tools in LDT. They can fill in behind areas and that is probably what is happening, is there a part of the grading that can go around a high point on the surface?