damon.sidel
2011-10-26, 12:54 PM
Check out the screen capture attached. On the left you'll see that that surfaces are subdivided so that the lower portion as half as many as the upper portion. Great. Then I applied my pattern-based panel system using the Triangle (flat) pattern as you can see on the right. Problem is, no matter how many subdivisions in the vertical direction, I can't get the vertices to line up the way I want. The lower portion is correct, but the upper portion starts with that half panel. Any way to change how the pattern starts and stops? I've been playing with the parameters, but can't find any combo that works.
Update: I can change the Offset of the U Grid so the pattern starts in a different position. But that's dependent on the size of the panel. I just want to offset it one panel, not have to measure.
Update: I can change the Offset of the U Grid so the pattern starts in a different position. But that's dependent on the size of the panel. I just want to offset it one panel, not have to measure.