Surface distribution - copying, diameters, annotations

[seba_k]

Hello,
I have 3 questions:

1) How can I copy/array reinfocement made by "Surface distribution" option? I tried the usual way of copying, but nothing happaned after that.
2) Is it possible to have different rebar diameter in one surface? Sections allow to change spacing between rebars, but you can have only one diameter :(
3) Can you make two different annotations of one surface of reinforcement?

Thank you in advance for help.

PS.: I'm using ASD 2012

[andrew.boardman1]

1) you need to make sure that you copy the AutoCAD_Structural_Detailing_Slab contour layer as well as selecting the bars.

2) I have not found this only way i found was to have 2 distribution plans.

3) what do you mean, if can you call off 2 lots of rebar on 1 line not with surface distribution, you can with reinforcement distribution not surface.

here is a example of Surface distribution (eurocode) with some reinforcement distribution i have done, a lot of the comments are text and is not the way i would normally call off bars but needs must.

[seba_k]

Thank you a lot for help! That's all I needed to know.