PDA

View Full Version : How can i do this assembly?



walter.mardones556715
2012-01-25, 01:05 PM
I need to do an assembly of this type, and i can not found the way, can someone help me?, inside the attached dwg there are more specific question. Thanks in advance. (sorry for my english):)

mjfarrell
2012-01-25, 01:39 PM
You will wnt to use a CONDITIONAL sub assembly to set you assembly to handle either case depending on the conditional parameters.

I think you will wnat the Conditional Cut or Fill sub assembly for this task.

mjfarrell
2012-01-25, 02:49 PM
I need to do an assembly of this type, and i can not found the way, can someone help me?, inside the attached dwg there are more specific question. Thanks in advance. (sorry for my english):)

Also, I do not see the other questions in your file. What are they exactly?

Do your best to post them in both your languge and english and I'll do my best to help.

mjfarrell
2012-01-25, 10:55 PM
OK, after much study I now see the 'other' questions.
This assembly is deceptively complex.
There are a few approaches one can take.
One includes use of the Sub-Assembly composer; which those NOT on subscription will not be able to take advantage of.
The other will use a combination of various pieces, the Generic Pavement Section, several generic Links, as place holders and the Link Multi.
I will try to produce a coherent tutorial to illustrate.

mjfarrell
2012-01-26, 08:24 PM
Check back shortly as I will be posting a link here once the tutorial is posted to the
Tutorials Page on my website. This could take about an hour.

For those following, I decided against using the Link-Multi sub assembly as mentioned above for reasons that I explain in the video. Mostly due to a lack of certain flexibility that some users may or may not require.

The Tutorial is located here: http://primeservicesglobal.com/tutorials/genericlinks.mp4