damon.sidel
2012-03-12, 03:42 PM
Anybody ever seen anything like this?
I created a Rhomboid panel system. I created a mass and applied the panel to the subdivided surface and the Border Tile parameter is set to Partial. Unfortunately, instead of cutting the panel at the right point, there is a bit of an offset. What's up?!
I was originally only using on the mass that I'm actually designing for my project, but then I tried it again in a new mass on a simple, rectangular form. Same problem.
I created a Rhomboid panel system. I created a mass and applied the panel to the subdivided surface and the Border Tile parameter is set to Partial. Unfortunately, instead of cutting the panel at the right point, there is a bit of an offset. What's up?!
I was originally only using on the mass that I'm actually designing for my project, but then I tried it again in a new mass on a simple, rectangular form. Same problem.