Export coordinates from a corridor

[xtcgr]

Here is the problem; corridor and its surface, etc are designed but there is no "obvious" way to get coordinates in order to layout the road in the field. There is the option to get COGO points from corridor via "create COGO POINTS" / "CREATE GROUND DATA" but this option refers only to points based on baseline in any station of the corrridor and not in any station i would like to. Any help will be highly appreciated.

[C3Dventurer]

If you are looking for a COGO point at say POB and then at PC, PT, Center of Radius etc., Home Tab>Create Ground Data Panel> Points> Create Points- Alignments> At Geometry Points.

[Richard McDonald]

Depending upon your country pack there will be various reports you can run from the tool box.

Alternatively the Geneio export tool for C3D works very well.

Regards