PDA

View Full Version : 2013 Connecting Feature Lines to Corridors



sbombardier
2013-03-13, 07:52 PM
I am working on a project to install a Multi-Use Path along side a existing road. I have created a Feature line from the surveyed data to represent the drainage swale, and another feature line to represent the edge of existing pavement, then projected them onto the profile.

I have created an alignment for the center line of the path. Now what I want to accomplish is to connect from the Edge of Multi-use path (BasicLane sub assembly), to the swale feature line, then to the Edge of Existing Pavement feature line. I have adjusted the elevations of the swale Feature line in the profile to allow for drainage. I will need to be able to show section cuts of the new swale.

Opie
2013-03-14, 08:00 PM
Using your alignment along the center line of the path, you should be able to add that alignment to the corridor as a baseline. You could then add your desired assembly to this baseline and target the sub-assemblies to the feature lines for horizontal and vertical.