dmingo
2013-09-20, 02:19 PM
I am trying to change coordinate systems from UTM-CSRS to MTM, but I keep getting a failure to convert error.
I have assigned the coordinate system to the drawing before using the mapimport command.
The source drawing that I am using was produced by 'Globalmapper' program using LiDAR data to create a contour drawing.
Any ideas anyone?
I have assigned the coordinate system to the drawing before using the mapimport command.
The source drawing that I am using was produced by 'Globalmapper' program using LiDAR data to create a contour drawing.
Any ideas anyone?