View Full Version : Hi........Question
charro_mech
2005-02-23, 07:17 PM
Hi
I'm using M. Desktop 6 and since few days ago i can't see dialog boxes in many commands, i.e., if i start the command extrude only prompt is active and options are not visible in a dialog box..............How can i activate the dialog boxes again? Is it a variable System?
Thanks for your help
Regards
Wanderer
2005-02-23, 07:23 PM
Hi
I'm using M. Desktop 6 and since few days ago i can't see dialog boxes in many commands, i.e., if i start the command extrude only prompt is active and options are not visible in a dialog box..............How can i activate the dialog boxes again? Is it a variable System?
Thanks for your help
Regards
check out this thread (http://forums.augi.com/showthread.php?p=84657&highlight=cmddia+dialog#post84657) which outlines dialog visibility... I assume it works for m desk too...
charro_mech
2005-02-23, 07:45 PM
Hi
CMDDIA was the problem..............
Thanks
charro_mech
2005-02-23, 07:54 PM
Hi
CMDDIA was the problem..............
Thanks
Wanderer
2005-02-23, 08:28 PM
Hi
CMDDIA was the problem..............
Thanks
great! don't know how those get changed sometimes, but, they do... ;)
Ron Oldenbeuving
2005-02-25, 12:01 AM
Sometimes the file dialog box wont come up, then use the FILEDIA command and change the setting to 1.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.