Mutiple Drawings

[tjh2]

I'm not able to open more than one drawing with Map. SDI is at 2 and it will not allow me to reset to anything else. Under Options/System, General Options, the Sdi box is grayed out and checked.

I unloaded the LDDT menu to no avail. I would apppreciate any advice.

Thanks

[Mike.Perry]

Hi

Please note I've *moved* this thread from the ACAD 2005 General (http://forums.augi.com/forumdisplay.php?f=58) Forum to this one as I feel this particular Forum is a more appropriate place for such a topic.

Thanks, Mike

Forum Moderator

[MHultgren]

Do you have the Civil menu loaded? If you have your default Map.ARG file saved on the server you can import it back in after you copy it to your Land Desktop support folder. I always instruct my users to take a few minutes to set both LDT and MAP up just the way they want it ( menus, toolbars, support paths & settings) and then export that to the server and to thier local Land Desktop installation folders overwriting the LDDT.arg for Land and the Map.arg for MAP. That way, when this happens, and believe me, it does quite a bit, it is a quick fix to get back to where they were. Usually, someone will go in and change the Object Detect and command invoke switch and as soon as they try to run an LDT command (or one of the keyboard commands located in the Macros.lsp file like ZE for zoom extents) LDT loads and SDI goes to grey. After you unload the Land and\or Civil menues, you will need to close Map and reopen it to change SDI back to 0.

[tjh2]

Thanks Mark It works fine now.