Daylighting Issues

[jehaywood964444978]

I work for a coastal engineering firm and I am designing the dredge prism. I am using a cooridor to do the grading and when the subassembly (DaylightMultiIntercept) is daylighting to the existing surface it will go through the first point of contact and then stop at the next point for some reason. This issues causes a fill scenario and throws off the volume calculations and misrepresents the design surface. If anyone has some input it would be greatly appreciated.

Jonny Haywood

[Michael.Shurgalla]

One option would be get rid of that daylight link, use the corridor feature to extract a linked feature line and then daylight that with a grading to surface. Linking the feature to the corridor will keep it dynamic. Take both the surfaces and paste them in a new clean surface and then run your volume.