jkipfer
2005-03-01, 10:32 PM
When creating a sheet list table from many drawings, you get one really long sheet list.
Is there a way to wrap the entire table so after a point it continues beside itself?
I see table direction in the Table Style Dialog box, but it's options are down and up.
I know you could copy side by side, delete and line up the table, but then should an entry change, you would get the table as specified in the style back again.
Thanks,
Jason
Is there a way to wrap the entire table so after a point it continues beside itself?
I see table direction in the Table Style Dialog box, but it's options are down and up.
I know you could copy side by side, delete and line up the table, but then should an entry change, you would get the table as specified in the style back again.
Thanks,
Jason