PDA

View Full Version : 2014 SECTIONS AT A ROUND ABOUT



rmk
2014-09-09, 08:28 PM
Attached is a roundabout with sections at A thru H. the first alignment ends at the center and a new one begins.
I need to place sample lines at these sections (radially) and create section views from the center outward.

Any ideas of how this can be accomplished? I know you can pick an existing pline for a sample line. but the section view doesn't seem to be right.

BlackBox
2014-09-10, 11:40 AM
Any ideas of how this can be accomplished?


Consider creating a separate Profile View for each section A-A, etc.

DI Dad
2014-09-16, 12:22 PM
I would suggest either connecting the two alignments with a radius or create a separate alignment around, be sure to leave a gap, and then reference the final surface in your sections.