jason_alligood677697
2014-12-30, 08:42 PM
I have produced sections using the overlaymill2 subassembly. Only two of the sections are displaying a hatch between the existing ground surface and the bottom of the mill layer. See attached imagehttp://forums.augi.com/attachment.php?attachmentid=98765&stc=1.
I have reviewed the code set setting in the view group properties, each section property, in the corridor property, etc. They are all set to the same code set style. However, it appears maybe the subassembly is unable to detect the surface for some reason. I am at a loss.
I have reviewed the code set setting in the view group properties, each section property, in the corridor property, etc. They are all set to the same code set style. However, it appears maybe the subassembly is unable to detect the surface for some reason. I am at a loss.