double line, dline command snaps not working

[jvoight]

Hello, I have acad lt 2005 when I use the double line command "DL" the snaps are turned off. If I type "s" at the command line for Snap option it has an ON/OFF toggle its set to on and still no snaps. I can turn snaps on by using the F3 key, but all of my default snaps are cleared and I have to pick each individually. When I exit the command the default snaps are restored. I have to manually turn snaps on each time I use the double line command.

Whats up with this? Is this the way its supposed to be?

Thanks Jim

[Mike.Perry]

Hi

Check out the following Technical Document on the Autodesk web site under the Knowledge Base section -

ID: TS48201 - Object snaps are turned off at random during drawing session (http://usa.autodesk.com/adsk/servlet/ps/item?id=2876715&linkID=2475874&siteID=123112)

Please note - Above document references AutoCAD LT 2000, but from what "Jim" has written it would appear the document still applies to AutoCAD LT 2005 LT.

Have a good one, Mike

[jvoight]

Thanks Mike, I found that after I posted.

You would think there would be an option to turn the snaps on for further uses...

Thanks for your help. jim