PDA

View Full Version : Polar Array



charliep
2005-04-25, 07:33 AM
I'm using Acad LT 2005 on Windows XP pro.
I'm trying to do a partial polar array eg. arch above an opening. When I use the "pick angle to fill" button" and click on the point I want the array to finish, the array goes beyond this.
There are two ways around this as far as I can tell; 1 - measure the angle and use this instead of "pick angle to fill";
2 - rotate the finish point around so it is the same relative angle from 0 as from the start point and use this as my "pick angle to fill".

I find both methods cumbersome. Is there a third easier way? (or fourth, fifth......)

kwong
2005-05-20, 03:58 AM
Instead of rotating the drawing, set your ucs to the base angle, then pick the angle you need.

kwong