commas in Sheet Set titles

[jamie.casile]

any work around for commas in title fields? for example - the use of alt+0160 or \U+00A0 for space....
thanks,
jamie

[Mike.Perry]

Hi

Have a browse of the following thread -

Getting area in a field to round up to a whole number. (http://forums.augi.com/showthread.php?t=13627)

Have a good one, Mike

[jamie.casile]

Hi. i took a look at the thread, but that is to add commas as a separator for 1000s in numbers. what i am looking for is to be able to add a comma to my sheet titles - as in 'SITE PLAN, VICINITY MAP, ZONING INFORMATION.'
Thank you,
jamie

[Mike.Perry]

Hi

So are you talking Sheet Sets and not! Fields?

Have a good one, Mike

[jamie.casile]

i am using the fields in my sheet set. the fields are on the plot sheets and referencing the 'current sheet title' of my sheet set.
-jamie

[RobertB]

i am using the fields in my sheet set. the fields are on the plot sheets and referencing the 'current sheet title' of my sheet set.
-jamie
But the real issue is that the SSM doesn't permit you to enter the comma, not the field.

[jamie.casile]

yes. i apologize. i am in the wrong forum, i guess.
thanks.
by the way, any fixes for the sheet set not being able to add commas???

[Mike.Perry]

Hi Jamie

Please note I have moved this thread from the AutoCAD Fields (http://forums.augi.com/forumdisplay.php?f=53) forum to this one...

Thanks, Mike

Forum Moderator

[Mike.Perry]

Hi

Have a browse of the following thread -

Use of symbols in SSM (http://forums.augi.com/showthread.php?t=13014)

Have a good one, Mike

[jamie.casile]

I read the thread you recommended, and therefore conclude that no commas in titles of sheets at the moment. is that correct? i am using autocad 2006. I thought i saw somewhere that it was an issue in 2005 and would hopefully be fixed by 2006. any chance of this?
thank you,
jamie

[Mike.Perry]

Hi

I read the thread you recommended, and therefore conclude that no commas in titles of sheets at the moment. is that correct?Yep! this is my understanding, plus Robert also indicated that to be the case in his above (http://forums.augi.com/showthread.php?p=160492#post160492) post.



i am using autocad 2006. I thought i saw somewhere that it was an issue in 2005 and would hopefully be fixed by 2006. any chance of this?I believe one or two people might have speculated it would be fixed in AutoCAD 2006, but for what it is worth (not a lot) I have not read / seen anything official from Autodesk regarding this particular issue / problem.

Have a good one, Mike

[sinc]

yes. i apologize. i am in the wrong forum, i guess.
thanks.
by the way, any fixes for the sheet set not being able to add commas???

It may be worth noting that it is only the Sheet Title that does not allow commas. You can have commas in other fields.

For example, you could use the Sheet Description field - that one allows commas. Or you could use a custom property in either your Sheet or Sheet Set.

[joshua.jones]

any work around for commas in title fields? for example - the use of alt+0160 or \U+00A0 for space....
thanks,
jamie
Check out this thread:

http://forums.augi.com/showthread.php?t=15172