Spokes
2005-08-23, 07:01 PM
I am working with a straight alignment that varies in width. When I process cross sections not all sections are the same width due to the irregular shape of the surface. Some sections are too wide to plot in columns and some will plot in columns. When plotting multiple sheets some of the wider cross sections are forced off a sheet being plotted next to another cross section rather than being added to a new sheet or in one column. At times if the cross section plotting settings page layout are changed just right, this problem does not occur. Changing a template and reprocessing cross sections in design control then plotting multiple sheets can bring the problem back. Any ideas?