publish from model tab

[jamie.casile80054]

is it incorrect to assume that the publish function using sheet set manager will also work if the files are in model space?
thanks
jamie

[Mike.Perry]

Hi

Honestly, I am not trying to be funny here - What happens if you try it? ie. Experiment.

Have a good one, Mike

[RobertB]

Sheets, in SSM-speak, are only layouts, never Model tabs.

[jamie.casile80054]

mike,
it isnt that i haven't tried, i just want to know if i am correct in my conclusion as i don't think anyone should assume anything.

[Mike.Perry]

it isnt that i haven't tried, i just want to know if i am correct in my conclusion as i don't think anyone should assume anything.Hi

Refer to Robert's post above (it answers your question).

Have a good one, Mike

[csorensen]

Sheets, in SSM-speak, are only layouts, never Model tabs.

We are starting to take a look at sheet sets to see if this will work for use. We do all of our drawings as model space. We do not use the layout tabs.
Going through the sheet set manager I noticed that all sheets get labeled as layouts. According to Robert it's never the Models tab. So, every time you go into a drawing you have to click on the models tab ? There isn't away to change this ?

Are there any good links/ tutorials out there for sheet sets ?

[Mike.Perry]

Are there any good links/ tutorials out there for sheet sets ?Hi

Take a look at the links in this post...

RE: importing .dwg into sheetsets

Have a good one, Mike