View Full Version : ditch subassemblies
2005-10-27, 04:18 PM
I'm trying to create a subassembly for a roadside ditch that forces a minimum ditch width/depth. Using the 'Basic Side Slope Cut Ditch' subassembly does not force a minimum depth ditch in fill conditions. My catch is hitting existing grade too early, and I want a minimum 2' deep ditch. Suggestions?
2005-10-27, 08:00 PM
Did you try changing the properties of the subassembly for the 'Basic Side Slope Cut Ditch'? You can do this by double clicking on the subassembly, this will bring up your properties window under parameters you should be able to make the necessary changes.
Hope this helps!
Powered by vBulletin® Version 4.1.11 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.