eckdahlrd
2006-01-16, 07:19 PM
I'm trying to edit the crown elevations of pipes (not gravity flow).
Using the panorama editor, I've gone through and changed the start crown elevations, and now need to edit the end crown elevations. For some reason, after I key in the correct end elevation and hit enter, it reverts back to the elevation that was previously (and incorrectly) indicated. I also noticed that at this point, the "adjusted" pipe is no longer in the drawing view.
I've got other networks in the drawing, they were all working perfectly, but now even those do not appear to be changing correctly.
Any suggestions?
Using the panorama editor, I've gone through and changed the start crown elevations, and now need to edit the end crown elevations. For some reason, after I key in the correct end elevation and hit enter, it reverts back to the elevation that was previously (and incorrectly) indicated. I also noticed that at this point, the "adjusted" pipe is no longer in the drawing view.
I've got other networks in the drawing, they were all working perfectly, but now even those do not appear to be changing correctly.
Any suggestions?