luke.104954
2006-02-14, 08:20 PM
I have a manhole that is in one of my intersections. On the plan view I can specify a labels reference alignment as to create one for the station/offset on road A Layout and another label with referencing off of road B for my second layout. The structure's reference alignment is set to " < n o n e > ". This works as it should.
When i try to repeat the same procedure with the profile view, the station shows up as ??? even after I enter a reference alignment in the profile label properties. The station only shows up in profile view if I change the reference alignment of the structure itself, and therefore I cannot have 2 labels showing different Alignment stations.
I tried to explain this one clearly... Any help would be appreciated
When i try to repeat the same procedure with the profile view, the station shows up as ??? even after I enter a reference alignment in the profile label properties. The station only shows up in profile view if I change the reference alignment of the structure itself, and therefore I cannot have 2 labels showing different Alignment stations.
I tried to explain this one clearly... Any help would be appreciated