units in position block placeholder

[peter.sedlacek]

i have made an block for elevation label with block placeholder. i used position, y coordinate value. my drawings are in milimeters, but according our standards, values in elevation labels are in meters. is it possible to manage this value somehow? is it possible to affect precision of it, not related to draving setup?

thanks...

[Mike.Perry]

i have made an block for elevation label with block placeholder. i used position, y coordinate value. my drawings are in milimeters, but according our standards, values in elevation labels are in meters. is it possible to manage this value somehow? is it possible to affect precision of it, not related to draving setup?Hi

Just checking...

Are you using Fields for this task ?

If yes, I will move this thread to the AutoCAD Fields (http://forums.augi.com/forumdisplay.php?f=53) forum.

If no, please ignore me.

+

If you are using Fields, take a look at the following post...

Formula using an Object's Area Field

Have a good one, Mike

[peter.sedlacek]

yes, i used fields, thanks for moving my message. i had a similar question regarding fields values on ADT forum, could you check it, please?
thank you very much for your advice.

[Mike.Perry]

Hi

yes, i used fields, thanks for moving my message.Done.

Thread moved from the AutoCAD 2006 General (http://forums.augi.com/forumdisplay.php?f=197) forum, to here ( AutoCAD Fields (http://forums.augi.com/forumdisplay.php?f=53) forum ).



i had a similar question regarding fields values on ADT forum, could you check it, please?
thank you very much for your advice.Done.

That thread can now be found here ( Layer color in a Field ).

Thanks, Mike

Forum Moderator