editing filled regions side by side

[Martin P]

Say I have 3 filled regions all next door to each other, I go into sketch mode to edit ONE of them - it changes the others - even if the lines are not locked, especially when dealing with angles this is bad. I edit one, I only want one to change, I wcan change the others myself if I want to. This is a real headache causer this one - Revit people, please make it stop.

[Phil Palmer]

This is only the case is the 3 filled regions were sketched at the same time ?
This is the nature of the filled region command
Surely if you do 'seperate' filled regions you are then OK ?

[Martin P]

Nope, 3 completely separate filled regions - although the borders overlap each other - adjusting one of them in sketch mode messes up the angles on the others, and the lines are not locked to each other.....