patricks
2006-05-09, 09:05 PM
I have a storefront type defined for glass block which has 8" regular grids, and at one place in my model I have the glass block curved at a radius between two doors. Now when I so a STC, it seems now more often that not, it will generate an error about segments being too small and it has to delete some segments, which of course interrupts the STC process and I have to go back and do it again. Then when I go to the curved glass block wall, I see that the last segment before the door is gone, so I just drag the wall end back over to the door, and that fixes it.
However the same problems continues to happen over and over and over again. Even if I get the error, go and fix the wall, then STC again, it will save just fine with no errors, but then the next time I STC later on, it will generate those same errors again, even though neither the doors nor anything else around that glass block wall has changed.
I also tend to get various "Cannot keep elements joined" messages when doing an STC. Anybody know why this happens?
However the same problems continues to happen over and over and over again. Even if I get the error, go and fix the wall, then STC again, it will save just fine with no errors, but then the next time I STC later on, it will generate those same errors again, even though neither the doors nor anything else around that glass block wall has changed.
I also tend to get various "Cannot keep elements joined" messages when doing an STC. Anybody know why this happens?