armin.majer
2006-05-19, 10:08 AM
I have the same problems described in post from June 2005 by eckdahlrd. ( "http://forums.augi.com/showthread.php?t=32130" )
I have HF2 already installed. (Which didn't resolve this)
The Problem occurs when using non-circle profiles only. Worst is rectangular profile where this annoying thing happens also when editing the elevation of the center-line. With egg-shape it happens only when editing elevation of the bottom, not when editing elev. of center-line or crown elevation of pipe.
Anyone out there with the same problem?
Do you have any other suggestions then installing HF2? Because if not this probably means I will have to re-install.
Thanks, Armin
I have HF2 already installed. (Which didn't resolve this)
The Problem occurs when using non-circle profiles only. Worst is rectangular profile where this annoying thing happens also when editing the elevation of the center-line. With egg-shape it happens only when editing elevation of the bottom, not when editing elev. of center-line or crown elevation of pipe.
Anyone out there with the same problem?
Do you have any other suggestions then installing HF2? Because if not this probably means I will have to re-install.
Thanks, Armin