sivampeta_dheeraj
2006-07-29, 10:11 AM
I am involved in designig pcb's using Autocad.A track or trace of PCB is defined by an enclosed area.The problem arises when these two enclosed areas (defined by lines) are very near to each other.
I would like to design a program in such a way that if that program is executed it should give me the results of enclosed areas which are nearer than some predefined value say 0.3mm.
What are the options available to me?
I would like to design a program in such a way that if that program is executed it should give me the results of enclosed areas which are nearer than some predefined value say 0.3mm.
What are the options available to me?