jkrulicki
2004-06-08, 08:49 PM
Recently subsribed to AUGI and looking for help with MDT6
Problem creating four prong tee nut -
Have a short cylinder with through, thin midplane extrusions in unconstrained positions
Successfully bent up three of the created outside bosses with minor issues but the last one will always bend up the entire side of the cylinder, rather than the last prong itself
I have tried copying, rotating and patterning (which mdt6 really does not like) to satsify the issue but it remains.
All suggestions are welcomed and thanks for your replies
j.krulicki
*zipped fille attached
Problem creating four prong tee nut -
Have a short cylinder with through, thin midplane extrusions in unconstrained positions
Successfully bent up three of the created outside bosses with minor issues but the last one will always bend up the entire side of the cylinder, rather than the last prong itself
I have tried copying, rotating and patterning (which mdt6 really does not like) to satsify the issue but it remains.
All suggestions are welcomed and thanks for your replies
j.krulicki
*zipped fille attached