I've developed a problem with the dce command

[droak]

I have been getting the following responce to the DCE command for the last few days.

<<< DIMCENTER DIMCEN = 0.0, not drawing center cross. *Invalid* >>>

I've used the same DimStyle for about 4 years and have not changed the settings that I believe control the centerlines (Center mark size = -9.00000E-02).

My layout/vport scale is .25 which I don't normally use, (I normally use 1.0).

I am creating my viewports with the Solview Command, I do normally use this method.

I've been scratching my head bald trying to reason this out, but I have nearly no hair left. Can someone give me a clue as to what has caused this. I can send you a drawing if you would need one.

Respectfully:
Darrell

[BrenBren]

Did you check your dimstyle - making sure that it is set to current - to see if something accidently got changed. Try increasing the size to see if that makes a difference - it may have something to do with the vport scale, I am not sure, but increasing the size may give a clue to that.

Also, make sure that the mark type didn't accidently get changed - that it is still set to mark or line.

Sometimes lisp routines will change settings without you being aware of it.

HTH

[Mike.Perry]

Hi

Post the drawing here within the Forums, then everyone can view and offer guidance.

Have a good one, Mike